Trusted by Brighton property owners for heat pump repair, AC service, furnace maintenance & complete HVAC installation throughout Michigan.
From emergency repair to planned installation, we deliver expert HVAC service across every specialty.
Replacing an aging HVAC system with properly sized, high-efficiency equipment can reduce energy costs by 30 to 50 percent. Professional installation covers equipment selection, ductwork modifications, refrigerant line installation, electrical upgrades, and thorough commissioning to verify rated SEER and AFUE output.
A professional HVAC inspection evaluates the complete system from furnace combustion and heat exchanger integrity to air conditioning refrigerant charge and electrical safety. Technicians document equipment age, efficiency ratings, and any code violations to give you a clear picture of system health.
Boiler systems demand specialized knowledge of hydronic circuits, expansion tanks, pressure relief valves, and combustion analysis. Our technicians diagnose issues ranging from kettling and low water pressure to faulty zone valves and circulator pump failures across gas, oil, and electric units.
Selecting the right heat pump means matching BTU capacity to your structure while accounting for climate zone, insulation levels, and existing ductwork. Professional installation ensures proper refrigerant charge, correct defrost timing, and verified auxiliary heat staging for demanding winter conditions.
When your heating or cooling system fails unexpectedly, rapid diagnosis is critical to minimizing discomfort and preventing secondary damage like frozen pipes or heat-related illness. Emergency technicians isolate the fault, whether electrical, mechanical, or refrigerant-related, and execute repairs on the spot.
Leaking and disconnected ductwork wastes up to 30 percent of conditioned air before it reaches living spaces, forcing your HVAC system to work harder and driving up energy costs. Professional duct repair seals joints, replaces damaged sections, and restores proper static pressure balance.
Professional AC tune-ups follow a multi-point inspection protocol covering thermostat calibration, condensate drain clearing, electrical connection tightening, and evaporator coil cleaning. Maintaining clean coils and proper superheat readings keeps your system running at peak rated efficiency.
Installing a mini-split system correctly requires precise wall penetration, vacuum-sealed refrigerant lines, and proper electrical isolation between indoor and outdoor units. Our technicians size each zone independently using BTU calculations to ensure consistent temperature control across every room.
Ductless mini-split systems require specialized diagnostics for inverter-driven compressors, electronic expansion valves, and multi-zone communication boards. Our technicians resolve issues including refrigerant leaks at flare connections, blinking error codes, frozen evaporator coils, and failing fan motors.
Indoor air quality suffers when ductwork harbors years of accumulated particulate matter, allergens, and biological growth. Thorough duct cleaning addresses every branch run, main trunk line, and register boot using agitation tools and high-powered vacuum extraction to restore clean airflow.
Air conditioning failures range from simple capacitor replacements to complex compressor and refrigerant circuit repairs requiring EPA Section 608 certified handling. Our technicians diagnose the root cause using superheat and subcooling measurements, amp draws, and pressure readings to restore full cooling output.
A comprehensive furnace tune-up includes combustion analysis, heat exchanger inspection, and verification of gas pressure at the manifold. Technicians clean burners, test flame sensor microamp readings, and confirm proper flue draft to maintain safe, efficient operation throughout the heating season.
Annual dryer vent cleaning reduces fire risk, lowers energy consumption, and extends appliance lifespan. Our technicians clear the full vent path from the dryer connection to the exterior hood, remove bird nests or debris from the termination point, and confirm unrestricted exhaust flow.
Smart thermostats from Ecobee, Nest, and Honeywell Home offer occupancy sensing, geofencing, and learning algorithms that adapt to your schedule automatically. Our technicians verify system compatibility, install the required wiring, and configure the device for optimal interaction with your specific HVAC equipment.
When your heat pump struggles to maintain temperature or runs continuously without reaching setpoint, the problem often traces to refrigerant leaks, failing capacitors, or degraded reversing valves. Skilled technicians restore rated HSPF and SEER performance through systematic component-level troubleshooting.
Brighton property owners know that HVAC emergencies do not wait for business hours. A failed furnace in January risks frozen pipes, and a dead air conditioner in August creates dangerous indoor heat. With 19,345 residents depending on reliable climate control, KIC Refrigeration provides 24/7 emergency HVAC service built to respond fast and fix the problem right the first time.
Rapid dispatch, accurate diagnostics, and fully stocked service vehicles are not optional in Brighton — they are essential. Our MI technicians evaluate every emergency call with system age, warranty status, and repair-versus-replace economics in mind, recommending the solution that makes the most financial sense for your situation. That honest approach saves Brighton property owners money.
What makes us different from every other heating and cooling company in the area.
Every technician on our team holds current NATE certification — the highest standard in the HVAC industry for installation and service competency. You get a technician who has passed rigorous exams on system diagnostics, refrigerant handling, and equipment commissioning.
We help you select equipment with the highest SEER2, HSPF2, and AFUE ratings that fit your budget, and we install it to manufacturer specifications so you actually achieve rated efficiency. Proper charge, proper airflow, proper duct sealing — the details that turn rated efficiency into real savings.
You receive a written estimate with itemized parts and labor costs before any work begins, and the final invoice matches. No diagnostic fees hidden in the repair bill, no surprise surcharges — just honest pricing you can verify and trust.
We carry full general liability and workers compensation coverage on every job. Our HVAC license is current in every state we operate, and we pull permits when local codes require them. Your property and our crew are fully protected on every visit.
If the repair does not solve the problem or the installation does not perform to specification, we come back and make it right at no additional cost. Our guarantee covers workmanship, parts, and system performance because half-finished work is not in our vocabulary.
Get the information you need to make confident HVAC decisions for your property.
HVAC repair costs in Brighton typically range from $150 to $500 for minor fixes such as capacitor replacement, contactor swaps, or thermostat wiring issues. Mid-range repairs like blower motor replacement or refrigerant recharging run $500 to $1,200. Major repairs — including compressor replacement, heat exchanger repair, or evaporator coil swap — cost $1,200 to $2,500 or more depending on equipment brand and system type. The final price depends on whether you have a furnace, heat pump, air conditioner, boiler, or ductless mini split, as parts and labor vary significantly between system types. Our NATE-certified technicians diagnose the issue accurately on the first visit, and KIC Refrigeration provides a written estimate with transparent pricing before any work begins. We never charge a diagnostic fee when you proceed with the recommended repair.
Yes. The EPA estimates that Energy Star certified smart thermostats save Brighton homeowners an average of 8 percent on heating and cooling costs annually, which translates to $50 to $150 per year for a typical household. Models from Ecobee, Nest, and Honeywell Home use occupancy sensors, geofencing, and learning algorithms to build a schedule around your actual habits, automatically lowering temperatures when you leave and restoring comfort before you return. Many smart thermostats also provide energy usage reports, filter change reminders, and maintenance alerts that help you keep your system running efficiently. Some Michigan utility providers offer rebates of $50 to $100 on qualifying smart thermostat purchases, further reducing the cost. KIC Refrigeration installs and configures smart thermostats to communicate properly with your specific HVAC system — including multi-stage equipment and heat pumps that require specialized wiring.
Heat pumps offer both heating and cooling from a single outdoor unit, making them significantly more energy-efficient than furnaces for moderate climates. A heat pump does not generate heat — it transfers it from outdoor air, which requires far less energy than burning gas or running electric resistance coils. Modern cold-climate heat pumps with variable-speed inverter compressors operate effectively down to minus 15 degrees Fahrenheit, making them viable in most Michigan locations. For Brighton homeowners with natural gas access, a dual-fuel system — heat pump for primary heating paired with a gas furnace for backup during extreme cold — often provides the best balance of efficiency and performance. Heat pumps also qualify for federal tax credits under the Inflation Reduction Act. KIC Refrigeration evaluates your specific climate zone, insulation levels, and utility rates to determine whether a heat pump, furnace, or dual-fuel system is the smartest investment.
We recommend professional HVAC maintenance at least twice per year for Brighton homeowners — once in spring to prepare your cooling system and once in fall to prepare your heating system. Each tune-up includes a comprehensive multi-point inspection covering filter replacement, refrigerant level verification, electrical connection tightening, thermostat calibration, condensate drain clearing, and performance testing. For the heating check, technicians also inspect the heat exchanger for cracks, test safety switches, and verify gas pressure on furnaces and boilers. Routine maintenance catches small problems — like a failing capacitor or a dirty flame sensor — before they cause complete system failures. Industry data shows that well-maintained HVAC systems last 15 to 20 years compared to 10 to 12 years for neglected equipment, and they operate 15 to 25 percent more efficiently throughout their lifespan.
The ideal time for HVAC replacement in Brighton is during the shoulder seasons — spring and fall — when demand is lower, equipment availability is highest, and scheduling is more flexible. Contractors are less booked during these periods, which means faster installation timelines and potentially more competitive pricing. You are also more likely to find manufacturer rebates, utility incentive programs, and promotional financing during off-peak months. From a technical standpoint, moderate temperatures allow your new system to be commissioned and tested under less extreme conditions. However, KIC Refrigeration completes HVAC installations year-round in Michigan and can often start within days of your approved estimate, even during peak summer or winter demand. If your current system is showing signs of failure, do not wait for the perfect season — a planned replacement is always better than an emergency one.
Most HVAC installations, major equipment replacements, and significant ductwork modifications in Brighton require a mechanical permit from the local building department. This applies to furnace and air conditioner replacements, heat pump installations, boiler swaps, and new ductless mini split systems. Minor repairs like part replacements and refrigerant recharges typically do not require permits. KIC Refrigeration handles all permitting, code compliance documentation, and scheduling of final inspections on your behalf — you do not need to visit any government office or coordinate with inspectors. Permits exist to ensure your system is installed safely and to code, which protects your home and preserves your equipment warranty. Unpermitted work can create liability issues and complicate future home sales. We ensure every project meets current Michigan mechanical codes and International Mechanical Code standards.
Real feedback from homeowners and property managers who trust us with their comfort.
"Replaced our entire HVAC system and the crew was phenomenal. Finished ahead of schedule and left the house cleaner than they found it."
"KIC Refrigeration installed our new heat pump system and the difference is incredible. Our energy bills dropped noticeably the very first month."
"Boiler kept cycling on and off. Technician found a faulty thermocouple and replaced it on the spot. No nonsense, no upselling. Just good honest work."
Professional heating and cooling services extending to neighboring cities and towns.